Structural metal bonding and component casting
Welding to join or fabricate metal components introduces heat distortion, and catalog parts rarely match the dimension a worn assembly actually needs.
What is failing
Joining or fabricating metal by welding puts heat into the assembly and warps it, and a catalog replacement part rarely matches the dimension a worn assembly actually needs. Machining a one-off from billet is slow and costly. Both routes stall the repair while production waits.
How AAS does it
AAS bonds metal to metal cold with structural adhesives and casts replacement parts, gasket seals, and support pads directly against the actual mating surface. The crew prepares both faces, applies the bonding system, and forms the part in place, so it fits the real geometry rather than a drawing. No molds, no machining of a blank, and no hot work.
The plant gets a part that fits the worn assembly exactly and a bonded joint with no heat distortion. Components are cast and bonded on site without molds or a fabrication shop.
How AAS delivers it
AAS performs Structural metal bonding and component casting work for Manufacturing, Marine & Offshore, and Oil & Gas operations across Baton Rouge and Louisiana, cold-applied and in place wherever possible, on your turnaround schedule. Crews are factory-trained Belzona applicators, the repair system is matched to the service conditions it will see, and urgent failures are covered by 24-hour on-call response. The result is a permanent, engineered repair that returns the asset to service without the cost or downtime of full replacement.
Related applications
Have equipment that needs to stay in service?
Tell us what is failing. We respond quickly, and we offer 24-hour on-call service.