FD Fan Blade Protection and Balance
Worn forced-draft fan blades rebuilt cold and coated to restore balance and the airflow the furnace needs.
What was failing
A forced-draft fan feeding a furnace pulls particulate-laden air across its blades hour after hour, and that particulate wears the blade tips down and roughens the faces. As the metal comes off unevenly, the rotor falls out of balance and starts to vibrate, which loads the bearings and shakes the whole assembly. The worn, roughened blades also drag against the air stream and move less of it, so the fan no longer delivers the airflow the furnace needs to run. Left to keep wearing, the imbalance and the lost airflow force the fan, and the furnace behind it, out of service.
How AAS approaches it
We take the rotor down and strip the blades to clean metal so we can see exactly where the tips and faces have worn. We rebuild the worn tips and faces cold with a Belzona composite, putting the metal back where the particulate took it and bringing the blade geometry back toward its original shape. Then we lay an erosion-resistant coating across the blade surfaces, smooth enough to cut the drag and tough enough to take the particulate. With the geometry rebuilt evenly across the blades, the rotor comes back toward balance, and the smooth surface restores the airflow the furnace needs while giving the blades a wear face that holds up.
Assess and strip
We pull the rotor and strip the blades to clean metal to see where the tips and faces have worn and how far the rotor has gone out of balance.
Surface preparation
We blast the blade surfaces to a clean, profiled metal so the rebuild composite and the coating bond properly.
Rebuild tips and faces
We rebuild the worn tips and faces cold with a Belzona composite, working with no heat so the blades see no distortion.
Coat the wear faces
We apply an erosion-resistant coating across the blade surfaces, smooth to cut drag and tough enough to take the particulate in the air stream.
Balance and return to service
We confirm the rebuilt geometry brings the rotor back toward balance, then hand the fan back ready to feed the furnace.
The result
From the job
Repair and protection work of this kind, performed by AAS crews across Louisiana.
Capabilities used here
Where this work happens
Other projects
Storage Tank Floor Reclamation
Corroded aboveground tank floor rebuilt and lined back to immersion service without cutting out plate.
View project
Centrifugal Pump Rebuild & Efficiency Restoration
Cold-rebuilding an eroded pump casing and lining it to restore clearances, no new casting required.
View project
Live Pipe Leak Seal & Composite Wrap
Live leak sealed and a degraded process line reinforced with an engineered composite wrap, no welding and often no shutdown.
View project
Wastewater Clarifier & Concrete Structure Relining
Spalled, rebar-exposed concrete clarifier rebuilt and relined for continued immersion service.
View project
Heat Exchanger Water Box Protection
Blasting, metal rebuild, and a barrier coating restore a corroded exchanger water box and tube sheet in cooling-water service.
View projectHave equipment that needs to stay in service?
Tell us what is failing. We respond quickly, and we offer 24-hour on-call service.